Each method below produces different data. We explain which is appropriate for your Patton, PA property situation before you commit.
Non-Viable
💨Spore Trap Air Sampling
Spore trap cassettes collect all airborne particles — viable and non-viable — and are analyzed under microscopy for mold genus identification and spore concentration. Results typically return in 24–48 hours from an accredited lab. Compared against an outdoor baseline, this data shows whether indoor spore counts are elevated and which genera are present. Standard method for routine Patton, PA residential and commercial air quality assessment.
Viable
🏭Viable Culture Air Sampling
Viable culture plates capture live, culturable mold spores that grow on culture media — allowing species-level identification and colony-forming unit counts. Results take 5–7 business days but provide species-level data that spore traps can't. Used when species-level identification matters: Stachybotrys confirmation, occupational health documentation, or situations where genus-level data from spore traps isn't sufficient for your Patton, PA use case.
Surface
🎖Surface Swab & Tape Lift Sampling
Surface sampling confirms whether visible discoloration in your Patton property is actually mold (not staining or efflorescence) and identifies the species present — affecting which removal protocol and PPE level is appropriate.
ERMI
🔋ERMI Floor Dust Sampling
Environmental Relative Moldiness Index (ERMI) sampling uses qPCR analysis on settled floor dust to identify and quantify 36 specific mold species — providing a historical picture of mold accumulation in a Patton, PA property rather than a snapshot of current airborne levels. Used for post-remediation verification, long-term occupant health investigation, and situations where previous mold activity may have settled into dust but isn't actively airborne.
HVAC
🏢HVAC Register & Return Air Testing
Testing directly at HVAC supply registers and return grilles identifies whether the air distribution system is distributing mold spores throughout the property. Elevated counts at registers compared to room-level samples confirm the AHU or ductwork as the amplification source — critical before any duct cleaning or coil remediation decision in your Patton building.
Clearance
📄Post-Remediation Clearance Testing
Independent post-remediation testing compares treated zone air samples to outdoor baseline — confirming indoor spore counts returned to acceptable levels before re-occupancy. Our Patton, PA clearance testing uses the same accredited lab protocol as pre-remediation sampling, producing directly comparable data that demonstrates the remediation achieved its objective.
